Repair / Problems / Cooling / Coolant is leaking

Cooling

Coolant is leaking

Do not rideAlso called: antifreeze leak, green or pink puddle, radiator leak, water pump leak

Spark plug fouled by coolant entering the cylinder
Spark plug fouled by coolant entering the cylinder
Corroded water pump impeller and seal
Corroded water pump impeller and seal
Coolant reservoir fitted to the frame
Coolant reservoir fitted to the frame
Radiator cap on a liquid-cooled motorcycle
Radiator cap on a liquid-cooled motorcycle
Water pump impeller inside the cover
Water pump impeller inside the cover

Coolant is usually green, blue, pink or orange and smells sweet. A leak shows as drips under the bike, wet hoses, crust at joints, steam, or a reserve tank that keeps needing top-ups. Outside leaks come from hoses and clips, the radiator, the water pump seal (it leaks from a small weep hole), the drain bolt, the reserve tank or the radiator cap seal. If the level falls with nothing visible outside, coolant may be leaking inside the engine.

Is it safe to ride?

Not until the leak is found and the level is correct. A bike that loses coolant overheats, and coolant on the rear tyre is slippery.

Quick checks first

  • Wipe the liquid with white paper: coloured and sweet smelling?
  • Engine cold: check the reserve tank level.
  • Look at hoses, clips and the radiator bottom.
  • Is the rear tyre wet?
  • Coolant pushing out of the radiator cap while the engine runs can mean combustion pressure is entering the cooling system (head gasket or cracked head).

Diagnose it step by step

1Is the liquid really coolant?

  • Oily brown: Oil leaking under the bike.
  • Clear water drips from the exhaust when cold: normal condensation.
  • Clear water from the air conditioner of a car parked nearby, or rain: not your bike.
  • Coloured and sweet: go to step 2.

2Engine cold, check with Check and top up coolant. Is the level low?

  • Yes: top up to UPPER and go to step 3.
  • No: the leak may be from the reserve tank overflow after hot running (a little is normal if overfilled). Recheck after a ride.

3Trace it with Find a coolant leak. Where is it?

  • Hose or clip: tighten or replace the clip or hose. Retest.
  • Radiator core or seam: go to Radiator is damaged, bent or blocked.
  • Water pump weep hole: the pump seal has failed. Workshop job; ride only after repair, because the seal can also let coolant into the oil.
  • Drain bolt: fit a new sealing washer when you Replace the coolant.
  • Thermostat housing: workshop, see Check the thermostat.
  • Nothing outside: go to step 4.

4Is the oil milky, or is there white smoke?

Do not add leak-stop products unless the maker approves them. They can block narrow radiator tubes.

Causes, most likely first

Cause How to confirm Fix
Loose clip or perished hose Wet hose end Find a coolant leak
Radiator damage Wet core, stone damage Find a coolant leak
Water pump seal Weep hole wet Workshop pump repair
Drain bolt washer Wet at bolt Replace the coolant
Head gasket (internal) Milky oil, white smoke Do a leak-down test

Related problems

Sources

Values marked K-Light 125 are for that reference bike. Use your own bike's manual for its values. Text CC BY-SA 4.0, Transitions Lab.